Basic Operation
Turning on and off the TV
■ Turn on the TV
Connect the AC input cable, if TV has a power switch, turn it on firstly. Press the
button on remote control can turn on TV from standby mode.
■ Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug
the set from the mains and aerial. When there is an accident power off, it is
recommended to unplug the power cable from the power socket.
■ No signal (In ATV mode)
When there is no signal and no button operation, the TV set will automatically enter
into the standby status after about 15 minutes. In PC-RGB mode, the TV set will
automatically turn off in 1 minute if no input signal. When VGA cable is connected,
the TV turns on automatically.
Programme Selection
■ Using the CH+/CH- on the panel of TV or on the remote control.
Press CH+ to increase channel number.
Press CH - to decrease channel number.
■ Using 0- 9 Digital Buttons.
You can select the channel number by pressing 0 to 9. (In ATV mode)
Example:
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.
■ Quick switch
When there is no menu displayed while the television signal on, press the ENTER
button to enter Quick switch interface, the screen will display a list of existing
programs logo (or name) order.
Press the arrow buttons to quickly select a program, press / button to turn the
page, when need select a wanted program, press the ENTER button to the selected
program, or press the button to exit the fast tapping interface, then watch the
program.
Volume Adjustment
■ Press the VOL+/- button to adjust the volume.
■ If you want to switch the sound OFF, press the .
■ You can release mute by pressing the or increase the volume.
To Next Page
Loading...
Need help?
General
