Predefined Program Mode
1. Follow the instructions for Mode Selection and select Pr1 for the
Predefined Program.
2. Press “Start” to initiate the program. The “Program” display will
show the program and step (1-01). The LED indicator next to
“Start” will flash. Press “Start” to begin the first step of program 1.
3. When each of the predefined steps is complete, the unit will beep
four times and the indicator next to the “Start” will flash to indi-
cate the next step is ready to be initiated (unless the beeper is
disabled).
4. Press “Start” to initiate each step after the previous step is com-
pleted.
Below is the list of each of the 12 steps in the predefined program:
Note: The shaking speed when indicated is 1400rpm.
Step 1: Pre-Heat cycle 68°C
Step 2: 10 minutes 68°C, shake
Step 3: 10 minutes 68°C, shake
Step 4: 1 minute 68°C, shake
Step 5: 5 minutes 68°C, shake
Step 6: 1 minute 68°C, shake
Step 7: 68°C ramp to 45°C - Ramp rate setting of 3.5°/min
Step 8: 1 minute 45°C, shake
Step 9: 1 minute 45°C, shake
Step 10: 1 minute 45°C, shake
Step 11: 15 minutes 45°C, shake
Step 12: 2 minutes 45°C, shake
END, no heat
13
To delete a program:
1. Place the system in standby.
2. Press and hold the “Select Down” and “Abort” buttons.
3. While holding the “Select Down” and “Abort”, press and release the
“Standby” button.
4. Use the “Select Up” or “Select Down” button to scroll through all
the available programs.
5. Once the desired program is selected, press and hold the “Abort”
button for approximately three seconds. The system will beep six
times to indicate that the program has been erased. Once the sys-
tem starts beeping, release the “Abort” button. “Used” will no
longer be indicated in the timer display.
Note: program 1 cannot be deleted.
To Next Page
Loading...
