VXi VoxStar
™
User Guide PAGE 10
PAIRING WITH A CELL PHONE
Keep headset and phone no less than 3 inches and no more than 3 feet apart while pairing. Keep other
Bluetooth devices at least 50 feet away, or turn them off. NOTE: The headset can be paired with up to 8
different devices but can only be connected to one at a time. It can only switch back and forth between
2 devices in Multipoint Mode.
1. Turn headset off.
2. Press the MFB until the light rapidly flashes blue and you hear the audio prompt “Power On” and keep
holding until you hear “Discovering.” IMPORTANT: Wait for all audio prompts and the blue, rapidly flash-
ing light. This may take up to 8–10 seconds. Release the MFB.
3. Put your cell phone into Bluetooth Search/Scan Mode per the manufacturer’s instructions.
4. Wait while the devices discover each other: This could take up to 2 minutes. Once the phone discovers
the headset, select “pair” and enter a passcode of “0000” if instructed. Once pairing is complete, the
headset’s rapid blue light will stop flashing and the phone may prompt you to ‘connect’ to the headset.
Enter “Yes” on the phone if prompted to connect to the headset. When connected, you’ll hear the
voice prompt , “Your headset is connected,” and the blue light will flash slowly (once every 3–4
seconds), indicating that the headset is in Standby Mode and ready to make or receive calls.
To Next Page
Loading...
Need help?
General
