VXi VoxStar
™
User Guide PAGE 12
MULTIPOINT MODE
Multipoint Mode allows you to pair and switch between two Bluetooth devices. The headset can be paired
with devices before or after enabling Multipoint Mode.
ENABLING MULTIPOINT MODE
1. Make sure any other Bluetooth devices are powered off or out of range.
2. Power on the headset, but release the MFB as soon as you hear the voice prompt “Power On.” The
headset should not be connected to any other devices and should display a double-blinking blue light.
3. Press and hold the MFB, Volume Up and Volume Down buttons, and then release all three at the
same time.
4. If successful, you should hear a 4 rising tone “fanfare.”
5. Power off the headset. It is now in Multipoint Mode.
6. If you have not already done so, pair the headset with the devices you want to use.
7. Once all this is completed, when you next power on the headset, you should hear the voice prompt
“Your headset is connected” as it connects to each device.
DISABLING MULTIPOINT MODE
Disabling Multipoint Mode does not affect device pairings.
1. Repeat steps 1–3 for enabling Multipoint Mode.
2. If successful, you should hear a 4 descending tone “fanfare.”
3. Power off the headset. Multipoint Mode is now disabled.
To Next Page
Loading...
Need help?
General
