T01120GB.fm 21
Operation
Engaging clutch
Once the engine has warmed up push throttle to full position
(downwards).
Winter operation! Extremely low temperatures require 2-3 minutes
warming up of the engine at idling speed. As a result of the low
temperatures, grease will have stiffened in the system. To overcome
the difficulties arising from this, warm up the engine and lift the
machine several times, then put system into operation by quickly
opening the throttle.
6.3 During operation
Keep breaker dry and clean. Avoid no-load strokes. Never allow the
hammer to run with throttle wide open when forcing away broken or cut
off material or when lifting the hammer. When lifting the hammer, the
engine is decelerated by releasing the gas lever in the handle.
6.4 After operation
6.4.1 Short-term interruptions
Press short-circuit button until engine comes to a complete stop.
6.4.2 Finishing of breaking work
Press short-circuit button until engine comes to a complete stop and
then close fuel valve.
6.4.3 Longer operational pauses
Clean hammer. Add corrosion preventative to fuel mixture and allow
engine to run for 5 minutes. Close fuel valve. Allow engine to carry on
running until the fuel in the carburettor is fully used up. Oil parts
susceptible to rust.
To Next Page
Loading...
Need help?
General
