Wacker Neuson BPU 2950 series User Manual (English)

Questions and Answers:

T
Terry MirandaAug 7, 2025
Why is my Wacker Neuson BPU 2950 plate not developing full speed?
- J
  Jennifer MaldonadoAug 7, 2025
  If your Wacker Neuson Power Tool engine runs but the plate does not reach full speed, several factors could be at play. Ensure the engine RPM is correctly set according to the manufacturer's recommendations, and the throttle control is adjusted to 3600 RPM at full throttle. Consider if the soil conditions are too wet, causing the plate to bog down. Also, inspect the drive belt or clutch for wear, and replace if necessary. Check the exciter pulley for slippage and replace the tolerance ring if needed. Finally, verify the exciter gears are correctly timed and the exciter bearings aren't binding. Check the oil level in the exciter and replace the bearings if necessary.
A
Adam WeberAug 12, 2025
How to fix Wacker Neuson BPU 2950 with engine running but no vibration?
- X
  xkeyAug 12, 2025
  If your Wacker Neuson Power Tool engine runs but there is no vibration, the issue might stem from a broken or loose belt, or the clutch not engaging. You should replace the belt or adjust its tension. Additionally, inspect the clutch for any damage and repair as needed.
W
wesley83Aug 17, 2025
What to do if Wacker Neuson BPU 2950 plate travels in reverse only?
- S
  Stephanie WilsonAug 17, 2025
  If your Wacker Neuson Power Tool plate travels in reverse only, it could be due to air in the control circuit, low oil level in the handle, leaking seals in the handle, or a leaking seal on the exciter piston. Bleed air from the system, fill oil to the level mark, and replace the seals as necessary.
S
Steven OrtegaAug 22, 2025
Why does my Wacker Neuson Power Tool plate pull to one side?
- A
  Adam WhiteAug 22, 2025
  If your Wacker Neuson Power Tool plate pulls to one side, the shockmounts may be damaged. You should inspect the shockmounts and replace them if necessary.