T00823GB
11
Caution!
Never change direction (turning radius less than 5
meters / 5 1/2 yards), exert lateral (sideways)
pressure, or tip the Power Cut during cutting (11)!
- Use a cutting disc only for cutting the materials it is
intended for. The proper type of disc must be used, for
either metals or concrete.
- The arbour hole (bore) of the cutting disc must fit the
shaft exactly. If the arbour hole is larger than the shaft
diameter, a spacer ring must be used (accessories).
- Use only cutting wheels approved by the DSA
(German Abrasive Disc Committee) or equivalent
organisation for freehand cutting at up to 4370 RPM (=
80 m/sec. at circumference) for 14“/355 mm discs, or
up to 5100 RPM (= 80 m/sec. at circumference) for
12“/300 mm discs.
- The disc must be free of defects (12). Make sure by
sound testing with a piece of wood. Do not use
defective cutting discs.
Always tighten the cutting disc mounting bolt to a
torque of 30 Nm. Otherwise, the cutting disc can
twist.
- Before starting the cutting disc, make sure you have a
steady footing.
- Put the Power Cut into operation only as described in
this instruction manual (13). Always place your left foot
in the rear handle and grasp the other handle firmly
(with thumb and fingers). Other starting methods are
not allowed.
- When starting the Power Cut it must be well supported
and securely held. The cutting disc must not be
touching anything.
- If the cutting disc is new, test it by running it at least 60
seconds at top speed. When doing this, make sure
that no persons or body parts are in the extended
swing range of the disc, in case it is defective and flies
apart.
- When working with the Power Cut always hold it
with both hands. Take the back handle with the right
hand and the tubular handle with the left hand. Hold
the handles tightly with your thumbs facing your
fingers.
- CAUTION: When you release the throttle lever the
disc will keep spinning for a short period of time
(free-wheeling effect.).
- Continuously ensure that you have a safe footing.
- Hold the Power Cut such that you will not breathe in
the exhaust gas. Do not work in closed rooms or in
deep holes or ditches (danger of poisoning by fumes).
- Switch off the Power Cut immediately if you
observe any changes in its operating behavior.
11
min. 5 m
12
13
To Next Page
Loading...
Need help?
General
