Starting up
T01126en.fm 44
7.3 Operating fluids
NOTICE:
The unit uses mineral oil products (gasoline and oil)!
Take special precautions when handling gasoline.
Smoking and open fires are not permitted (danger of explosion).
Fuel mixture
The cut-off saw engine is a high-performance two-cycle engine. It is
operated with a mixture of fuel and two-cycle engine oil.
The engine is designed for use with normal unleaded gasoline with a
minimum octane rating of 91 ROZ (87 R+M)/2. If this octane is not
available, you may also use fuel of a higher octane rating. This will not
damage your engine.
For optimum engine performance and for the sake of your own health
and the environment, always use unleaded fuel! Do not use fuel that
contains alcohol.
36
Fuel 50:1
+
1,000 cm³ (1 liter) 20 cm³
5,000 cm³ (5 liters) 100 cm³
10,000 cm³ (10 liters) 200 cm³
1.0 Us-gal 2.5 floz.
2.5 Us-gal 6.4 floz.
5.0 Us-gal 12.8 floz.
Preparing the correct gasoline/oil mixing ratio:
50:1 Mix 50 parts of fuel with one part of oil.
To Next Page
Loading...
Need help?
General
