T01127en.fm 61
Maintenance work
8.6 Checking the ignition spark
Insert the combination wrench (9) between the hood and cylinder, as
shown in the figure.
NOTICE!
Do not insert the wrench into the spark plug hole; just make contact
with the cylinder (otherwise you may damage the engine).
Press the unscrewed spark plug (10), with the spark plug terminal cap
firmly attached, against the wrench using insulated pliers (away from
the spark plug hole!).
Press the multifunction switch (11) to the "I" position.
Pull out the starter rope firmly.
If the spark plug is functioning properly, you must see a spark plug be-
tween the electrodes.
58
To Next Page
Loading...
Need help?
General
