T00964en.fm 73
Guide cart
9.2 Safety information
9.2.1 The supports for the cut-off saw must be clean before inserting the
BTS.
9.2.2 The notched bolt must be correctly locked to prevent the cut-off saw
from coming loose while you are working.
9.2.3 Make sure that the clamping lever for setting the cutting depth and the
star knob for adjusting the handle are tight during the cutting process.
9.2.4 In order to prevent malfunctions, the guide cart should be cleaned us-
ing water after each use.
9.2.5 During breaks or while in storage or transport place the machine on a
flat foundation and secure it from rolling off or tipping over.
9.2.6 Immediately after completing the cutting process, bring the throttle le-
ver into the idle position (forward).
To Next Page
Loading...
