Safety instructions
SV00046GB.fm 10
3.2.13 Drilling and breaking hammers have to be disconnected from the
electric mains before changing tools.
3.2.14 The tools always have to be in perfect conditions.
3.2.15 Do not operate this machine in areas where explosions may occur.
3.2.16 Do not misuse the electric cable to pull or lift up the unit or to pull the
plug out of the socket. Protect cable from heat, oil and sharp edges.
3.2.17 Electric equipment and material may only be used if they comply with
the operational and local safety requirements. They must be in proper
conditions and they must be maintained in this condition.
3.2.18 Do not expose electric tools to rain. Do not use electric tools in damp
or wet surroundings.
3.3 Safety checks
3.3.1 Drilling and breaking hammers may only be operated with all safety
devices installed.
3.3.2 Before starting operation, the operator has to check that all control and
safety devices function properly.
3.3.3 Before starting operation, the overload clutch of drilling hammers has
to be checked for proper functioning.
3.3.4 Regularly check cable for damage.
3.3.5 In case of defects of the safety devices or other defects reducing the
operational safety of the drilling and breaking hammers, the supervisor
has to be informed immediately.
3.3.6 The machine must to be switched off immediately in case of defects
jeopardizing the operational safety of the equipment.
To Next Page
Loading...
Need help?
General
