SV00046GB.fm 11
Safety instructions
3.4 Maintenance
3.4.1 Only use original spare parts. Modifications to this machine are subject
to the express approval of the Wacker Company. All liabilities shall be
refused in case of nonobservance.
3.4.2 Disconnect the drilling and breaking hammer from the electric mains
before carrying out maintenance and repair jobs.
3.4.3 Work on the electric parts of the machines may only be carried out by
skilled technicians.
3.4.4 All safety devices must be reinstalled properly immediately after
maintenance and repair jobs have been completed.
3.5 Transport
3.5.1 When being transported on vehicles, precautions have to be taken that
these hammers do not slip or turn over.
3.6 Maintenance checks
3.6.1 According to the conditions and frequency of use, drilling and breaking
hammers have to be checked for safe operation at least once every 6
months by skilled technicians, such as those found at Wacker-service
depots and have to be repaired if necessary.
Please also observe the corresponding rules and regulations valid in your
country.
To Next Page
Loading...
Need help?
General
