Operation
T00730GB.fm 16
7.3 Notes on correct handling
Place the electric breaker with tool on the material in question and
switch on by pressing the switch lever.
After a few seconds the electric breaker reaches its full percussion
rate.
Exploit the weitht of the electric breaker when working.
Applying great force against the surface being worked does not
improve the performance of the tool.
Apply a pressure of at least approximately 100 N (22 lbs) on both
handles to avoid no-load strokes and to guarantee a comfortable
operation.
Do not place the chipping tool to far from the edge, thus making it
possible to split off the material being worked on. This stops the tool
from jamming and helps increase the demolition performance.
To Next Page
Loading...
Need help?
General
