Operation
T00730GB.fm 15
7. Operation
7.1 Attaching the tool
1. Swivel catch (9) on tool holder (11) outwards.
2. Clean shaft (10) and grease slightly.
3. Insert tool right in.
4. Press catch (9) on tool holder (11) right back.
Only use sharp tools!
Only use tools with perfect shaft (10) to avoid recoil!
7.2 Connection
Check before connecting:
1. The mains voltage must be the same as that indicated on the
nameplate (12)..
2. The electric breaker is operated with (light current) (see technical
specifications).
3. Check whether the necessary fuse is available in the mains
supply(see technical specifications).
4. The electric breaker is fully insulated and there is therefore no
green/yellow PE conductor in the power supply cable .
To Next Page
Loading...
Need help?
General
