Wacker Neuson G 2.5A

1A-12
1A OPERATION G2.5A
1.19 Engine Maintenance
The Periodic Maintenance Schedule below lists basic maintenance intervals for the engine and generator. Please
read the detailed maintenance procedures for the engine described in engine Owner’s Manual. This manual was
supplied with the generator. Replacement copies of these manuals can be ordered from WACKER Corporation or
directly from the engine manufacturer.
1.20 New Machines
Change engine oil and replace oil filter after the first 20 hours of operation.
1.21 Periodic Maintenance Schedule
1.22 Changing Oil
Drain oil while engine is still warm.
1. Remove oil fill plug (g) and drain plug (h) to drain oil.
2. Install drain plug.
3. Fill engine crankcase with recommended oil up to
level of plug opening (i).
Oil Capacity: 21 oz. (0.6 liters)
4. Install oil filler cap.
Note: In the interests of environmental protection, place
a plastic sheet and a container under the machine to
collect any liquid which drains off. Dispose of this liquid
in accordance with environmental protection legislation.
1005SD53
h
g
i
Check engine oil. Fill to correct level.
Check air cleaner.
Clean air cleaner.*
Change engine oil.
Check sediment cup at carburetor.
Clean and adjust spark plug.
Clean spark arrester (optional accessory).
Check shockmounts. Replace when necessary.
Check and adjust valve clearance.*
Clean fuel tank.*
Check condition of fuel line. Replace when necessary.
* Service more frequently in dusty conditions.
Daily
Before
Starting
Every 3
months or
50 hours
Every 6
months or
100 hours
Every year
or 300
hours