WAGNER AG-19 - Page 21

21
AG 19
GB
5
6
7
8
Flat side of
handle seal
(toward gun head)
Bev
elled side of
handle seal
(toward handle)
5. Loosen the tting (5) with a wrench and pull the lter compartment (6)
and lter (7) out of the gun.
6. Insert the correct gun lter (7) into the lter compartment (6) (narrow
end of lter faces upwards).
7. Place the handle seal (8) into the gun head with the at side of the seal
toward the gun head.
8. Insert the lter compartment (6) back into the gun and screw it securely
into place.
9.
Connect a Wagner original high-pressure hose to the material inlet on the
airless gun.
Using two wrenches (one on the gun and one on the hose),
tighten securely.
Before connecting to the airless spray device, check that all parts
of the gun and hose are screwed rmly and securely into position.