Paint straining
It is recommended that in order to avoid premature tip
and lter clogging you should strain your paint before
spraying. Follow manufacturer’s recommendations.
Select tip and gun lter
Use the proper gun lter based on the tip size being used.
Tip Size Paint Filter
XS
40° spray angle/
0,23 mm holeg
For thin materials like acrylic
paints, primers, stains...
Red
M
50° spray angle//
0,38 mm hole
For thick materials like
internal emulsions, latex
paints, hollow-space
sealants..., ...
yellow
Locking and unlocking the gun
WARNING
Always lock the trigger o when attaching the spray tip
or when the spray gun is not in use.
Locking the gun
The gun is secured when the
trigger lock is at a 90° angle
(perpendicular) to the trigger
in either direction.
Unlocking the gun
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
Plugging in the sprayer
1)
Check that the ON/OFF switch is in the OFF
postion.
O
2) The connection must be made by
correctly grounded plug socket.
Pressure relief procedure
WARNING
Be sure to follow the pressure relief procedure when
shutting the unit o FOR ANY PURPOSE. This procedure
is used to relieve pressure from the spray hose.
1)
Lock the spray gun o and
ip the ON/OFF switch to the
OFF position.
SPRAY
PRIME
O
2) Turn the PRIME/SPRAY knob
to PRIME.
3) Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4) Lock the spray gun.
Important information
To Next Page
Loading...
