1
2
A
B
3
4
A
B
5
10
EN
LOAD MATERIAL
These steps will prime the system and get it ready
to spray.
YOU WILL NEED
• The material you plan to spray
• Extension cord
• Waste bucket
Recommendation: It is good practice to perform
the steps on this page using water to familiarize
yourself with the function of the unit as well as to
ensure the unit is set up properly.
Recommendation: Always use new spray material
or material that has been thoroughly strained. Old
material often contains debris that can clog the
system.
tention
Take care to prevent material spills. Make sure
to use drop cloths or mask anything that is in the
spraying area and could accidentally be sprayed.
1. Fully depress the pusher stem to make sure the inlet ball is
free.
The pusher stem will only travel approximately 1/8”
and will automatically return back to its original
position once released.
2. Place a full container of spraying material underneath the
suction tube (A). Hold the return tube into a waste container
(B).
3. Turn the PRIME/SPRAY knob to PRIME.
4. Plug in the sprayer and slowly turn the pressure control knob
clockwise to setting ‘2’.
Allow pump to run until you see spray material owing from
the return tube (B).
5. Switch the pump OFF (0) by turning the pressure control knob
completely counterclockwise.
Place return tube back into material container and clip return
tube and suction tube together.
To Next Page
Loading...
Need help?
General
