1
2
1
2
SPRAY
PRIME
3
4 5
EN
9
BEFORE YOU BEGIN
This section contains instructions that will be
repeated throughout this manual. Read and
understand this section before using the equipment.
SPRAY GUN TRIGGER LOCK
Be careful when handling the spray gun so you do
not accidently spray yourself.
The high pressure paint stream could pierce your
skin causing serious injury. If an accident happens
see detail procedures in the Safety Information
section on pages 3-4.
See physician immediately and bring this instruction
manual.
Engage the trigger lock whenever instructed.
1. To lock the trigger, ip the trigger lock down until it stops in
place behind the trigger.
2. To unlock the trigger, ip the trigger lock up until it snaps into
place on the gun handle.
PRESSURE RELIEF PROCEDURE
Be sure to follow the Pressure Relief Procedure
when shutting the unit o for any purpose. This
procedure is used to relieve pressure from the spray
hose. Failure to do so could result in serious injury.
Perform the Pressure Relief Procedure whenever instructed.
1. Lock the spray gun (see “Spray Gun Trigger Lock”, above).
2. Turn the PRIME/SPRAY knob to PRIME (see item 4, previous
page).
3. Turn the power OFF (turn pressure control knob to “0”).
4. Unlock the spray gun. Briey pull the trigger to fully relieve
pressure from the system.
5. Lock the spray gun.
To Next Page
Loading...
Need help?
General
