WAGNER CONTROL PRO 250 M - Maintenance and Spare Parts; Inlet and Outlet Valve Maintenance; Spare Parts Identification and Ordering

24
Control Pro 250 M
GB
Maintenance and repairs
Danger
Before carrying out any work on the device, relieve the pressure and unplug the power plug from the socket.
a) Cleaning the inlet valve
i
If any problems occur when the paint is sucked up, the intake valve needs to be cleaned or replaced. Problems can
be avoided by cleaning and servicing the device properly.
1. Detach the suction hose from the basic unit.
2. Remove the inlet valve (Fig. 26, 1) from the base unit using a wrench (20) or hex key (10mm).
3. Remove the valve seat (Fig. 26, 2), ball (3) and O-ring (4) from the inlet valve.
4. Clean the inlet valve mount and all components thoroughly with a suitable cleaning solution or replace them if necessary.
5. Lubricate the O-ring (Fig. 26, 5) on the inlet valve.
6. Place the valve seat, ball and O-ring back in the inlet valve.
7. Drehen Sie das Einlassventil wieder in das Spritzgerät.
b) Cleaning the outlet valve
i
If the spray pattern is poor, the outlet valve may need to be cleaned or replaced.
Problems can be avoided by cleaning and servicing the device properly.
1. Remove the high-pressure hose from the base unit using a wrench (17).
2. Loosen the screw (hex key ( 2.5 mm)) on the outlet valve (Fig. 27), but do not remove it.
3. Remove the outlet valve (Fig. 28, 1) from the base unit using a wrench (16).
4.
Clean the outlet valve mount and the outlet valve thoroughly with a suitable cleaning solution or replace the outlet valve if
necessary.
5. Put the new or cleaned outlet valve back in.
6. Re-tighten the screw (Fig. 27).
Spare Parts List (Fig. 29)
Pos. Description Order No.
1 Spray gun assembly (incl. nozzle holder) 0517100
2 Nozzle 517 (for thick materials, e.g. interior wall paints)*
Nozzle 311 (for thin materials, e.g.
lacquers)*
0517517
0517311
3 Nozzle holder 0517200
4 Sealing set 0517900
5 High-pressure hose, 9 m 0517801
6 Carry handle 0580175A
7 Door (1 pc.) 0580041B
8 Suction hose and Return line 0580159A
9 Clip (suction hose) 9890222
10 Clip (return line) 0327226
11 Return line 0512371
12 Clip (1 pc.) 0512390
13 Filter housing 0580154
14 Filter 0580155
15 Outlet valve 0580072A
16 Repair kit for inlet valve 0580391
17 Inlet valve housing 9885553
* Wearing part: Not covered by warranty