Description (Fig. 1)
1 Suction hose 2 Pressure regulator with integrated ON/OFF switch
3 Carry handle 4 Integrated toolbox for nozzles and small parts
5 Nozzle 517 (for thick materials, e.g. interior wall paints) 6 Spray Gun
7 Nozzle holder 8 Nozzle 311 (for thin materials, e.g.
lacquers)
9 High-pressure hose 10 Selector switch
11 Return hose 12 Hose connection
13 Inlet lter 14 Inlet valve pusher
15 Operating instructions
Coating Materials Suitable for Use
Dispersion and latex paints for interior use.
Water-based and solvent-containing lacquers and glazes. Paints, oils, release agents, synthetic enamels, PVC lacquers, undercoats,
base coats, llers and anti-rust paints.
i
Another nozzle size may be used, depending on the material to be processed.
Thin materials: Nozzle 311
Thick materials: Nozzle 517
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and acidic coating substances.
Flammable materials
In order to ensure compatibility of the coating substance with the materials used to manufacture the device, please
contact Wagner Service in cases of doubt.
Field of application
Coating interior walls and outside objects (e.g. garden fences, garage doors, etc.).
Required tools and auxiliary material
•
Wrench (13, 16, 17, 20) and/or adjustable wrench (2 pcs.) and hex key (10 mm)
•
Hex key (2.5 mm)
•
Empty container
•
A large piece of cardboard
•
Covering material
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a consequence of sprayed material entering the
socket!
Mask all the areas and objects that are not to be spray painted, or remove them from the work area.
No liability is assumed for damage due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All such surfaces must therefore be completely
covered.
i
Pay attention to the quality of the adhesive tape used. Do not use excessively strong adhesive tape on wallpaper and
painted surfaces, in order to avoid damaging these surfaces when removing the tape. Remove adhesive tape slowly
and evenly; do not use jerky movements. Do not leave adhesive tape on surfaces any longer than necessary, in order to
minimise the possibility of residues when removing. Also observe the adhesive tape manufacturer's instructions.
Preparation of the Coating Material
Using Control Pro 250 M interior wall paints, varnishes and glazes can be applied by spraying without diluting them, or by diluting
them slightly. Detailed information is available in the technical data sheet of the manufacturer ( Internet download).
1.
Stir the material thoroughly and dilute it in the container as per the recommended dilution (an agitator is recommended for
stirring).
To Next Page
Loading...
Need help?
General
