WAGNER CONTROL SPRAY QX5

SETUP
6
EN
MATERIAL PREPARATION
i
Material to be sprayed may need to be strained to remove any impurities in the
paint which may enter and clog the system. Impurities in the paint will give
poor performance and a poor nish.
SPRAYABLE MATERIALS WATER AND OILBASED
• Semi-Transparent stain
• Solid stains
• Lacquers
• Urethanes
• Decorative paints (thinning may be necessary)
• Latex and oil-based paints (thinning may be necessary)
*THINNING THE MATERIAL
Before spraying, the material being used may need to be thinned with the proper solvent as specied
by the material manufacturer. Never exceed the thinning advice given by the coating manufacturer.
If thinning is necessary, use the proper solvent as specied by the material manufacturer. Never
exceed the thinning advice given by the coating manufacturer.
i
Only thin the material if absolutely necessary to improve spray performance.
Optimal spray performance should be acheived simply by adjusting the various
controls on the unit.
Do not thin with materials that have a ashpoint below 100°F (38°C).
i
For a video showing how to set up the Control Spray QX5, visit:
www.wagnerspraytech.com/controlsprayQX5