SETUP
6
EN
SPRAYABLE MATERIALS WATER AND OILBASED
• Latex and oil-based paints
• Decorative paints
• Semi-Transparent stain
• Solid stains
• Water-based lacquers
• Urethanes
MATERIAL PREPARATION
Material to be sprayed may need to be strained to remove any impurities in the
paint which may enter and clog the system. Impurities in the paint will give
poor performance and a poor nish.
*THINNING THE MATERIAL
Before spraying, the material being used may need to be thinned. Never exceed the thinning advice
given by the coating manufacturer.
If thinning is necessary, use water for water-based materials, mineral spirits for oil-based materials.
Only thin the material if absolutely necessary to improve spray performance.
Optimal spray performance should be acheived simply by adjusting the various
controls on the unit.
Do not thin with materials that have a ashpoint below 100°F (38°C).
For a video showing how to set up the FLEXiO 2500/3500, visit:
www.wagnerspraytech.com/flexio2500support
www.wagnerspraytech.com/flexio3500support
To Next Page
Loading...
