19
40 ccm - 300 ccm.
SERVICE MANUAL
EDITION 01/2012 PART NO. DOC367866
5.2 DISMANTLING / MOUNTING
See safety regulations in chapter 2!
After disassembly:
Treat all parts with a suitable cleaning agent.
Inspect all parts for traces of wear and replace if necessary.
Change all parts contained in the service set.
SIHI_0004_GB
WARNING
Incorrect maintenance/repair!
Risk of injury and damage to the equipment
Repairs and part replacement may only be carried out by specially
trained staff or a WAGNER service center.
Before all work on the unit and in the event of work interruptions:
- Switch off the energy/compressed air supply.
- Relieve the pressure from the spray gun and unit.
- Secure the spray gun against actuation.
Observe the operating and service instructions when carrying
out all work.
WARNING
Overpressure!
Risk of injury from bursting components
Never change the safety valve setting.
SIHI_0026_GB
SIHI_0134_ENG
WARNING
Flying parts!
Risk of injury
➞ Before dismounting a part from the fan motor, this must be
disconnected from the compressed air system:
1. Remove air hose.
2. Set spherical valve to vent position.
To Next Page
Loading...
