4
W 350
AUS
3. Safety Instructions for Spray Guns
•
The device may not be used in workplaces covered by the explosion-protection
regulations.
•
There must be no sources of ignition such as, for example, open res, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
•
Do not spray any substances whose hazard potential is not known.
•
Before working on the spray gun remove the power plug from the socket.
•
Do not use the spray guns to spray ammable substances.
•
The spray guns are not to be cleaned with ammable solvents.
•
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the specications given by the substance
manufacturer.
•
Caution! Wear breathing equipment: Paint mist and solvent vapors are damaging to
health. Always wear breathing equipment and only work in well ventilated rooms or
using supplementary ventilating equipment. It is advisable to wear working clothing,
safety glasses, ear protection and gloves.
CAUTION: DANGER OF INJURY!
Never point the spray stream towards human beings or animals.
Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Attention! Never operate the device if the nozzle seal is either
damaged or missing. If the nozzle seal is either missing or damaged
liquids can enter the device and increase the risk of an electric shock.
Check the nozzle seal before each use.
•
When working with the W 350 indoors as well as outdoors ensure that no solvent vapors
are sucked in by the spray gun.
•
When working outdoors, be aware of the wind direction. Wind can carry the coating
substance across greater distances - thus causing damage. When working indoors, provide
for adequate ventilation.
•
Do not let children handle the device.
•
Never open the device yourself in order to carry out repairs in the electrical system!
The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1, item 11) do not operate the unit further! Dismantle
and clean the ventilating hose, valve and diaphragm and replace the diaphragm
if necessary.
•
Do not lay the spray gun.
With original WAGNER accessories and spare parts, you have the guarantee that
all safety regulations are fullled.
To Next Page
Loading...
Need help?
General
