5
W 350
AUS
4. Description/ Scope of delivery
Description/ Scope of delivery (Fig. 1)
1) Air Cap 2) Nozzle
3) Union nut 4) Spray gun front part
5) Trigger 6) Spray gun rear part
7) Air lter cover 8) ON/OFF switch (located on both sides)
9) Material volume adjustment 10) Container
11) Ventilating hose 12) Valve
13) Stir stick 14) Replacement nozzle seal*
15) Lubricating grease*
* This is inside the container: remove it before starting operations!
5. Coating Materials Suitable for Use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear
finishes, automotive finishes, staining sealers and wood sealer-preservatives.
6. Coating Materials Not Suitable for Use
Wall paints, materials that contain highly abrasive components, facade paint, caustic
solutions and acidic coating substances. Flammable materials.
7. Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Thinning recommendation
Sprayed material
Glazes undiluted
Wood preservatives, mordants, oils, disinfection
agents, plant protective agents
undiluted
Paints containing solvents and water-soluble paints,
primers, vehicle coating paints, thick-lm glazes
dilute by 5 - 10%
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulls your requirements.
To Next Page
Loading...
Need help?
General
