WAGNER W 975 FLEXIO User Manual

49
W 950 Flexio/ W 975 Flexio
Wall paint
49
W 950 Flexio/ W 975 Flexio
EN
Problem Cause Remedy
Spray jet is
uneven/ not
constant
•
Coating material in container
running out
•
Nozzle seal worn
•
Air lter heavily soiled
•
Filter clogged at suction hose
•
Rell
•
Replace
•
Change
•
Clean lter
Coating
material causes
"paint tears"
•
Too much coating material
applied
•
Viscosity of coating material too
low
•
Turn the material volume
setting to the left
Spray excess material on the
wall using the inking roller
•
Reduce the quantity of
material and apply in several
layers
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much material quantity
•
At a low quantity of material, wide
spray jet selected (black/yellow)
•
Reduce distance
•
Turn the material volume
setting to the left
•
Switch to narrow jet spray
(white)
Width of paint
spray cannot be
adjusted
•
Adjustment ring is not connected
to the peg on the air cap
•
Air screen is clogged up
•
Connect adjustment ring and
peg
•
Disassemble and clean the
spray head
Poor covering
capacity on the
wall
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
•
The material quantity and spray
jet do not correspond with each
other
•
The material you are
spraying should be at room
temperature
•
Cross spray (Fig. 8)
•
Closer to the object
•
Optimise the settings
Coating
material cannot
be atomised
•
Multifunction switch is set to
"Clean"
•
Turbine is defect
•
Set the multifunction switch
to "ON"
•
Please contact Wagner
Service

WAGNER W 975 FLEXIO Specifications

General

Brand	WAGNER
Model	W 975 FLEXIO
Category	Paint Sprayer
Language	English