WAGNER W 975 FLEXIO

56
W 950 Flexio/ W 975 Flexio
56
W 950 Flexio/ W 975 Flexio
EN
Varnish paints and glazes
1
2
ProblemProblem CauseCause RemedyRemedy
Atomisation too
coarse
•
Material volume too large
Material volume adjusting screw
turned too far to the right
•
Nozzle contaminated
•
Coating material too thick
•
Air lter heavily soiled
•
Too little pressure build-up in
container
•
Turn material volume
adjusting screw to the
left
•
Clean
•
Dilute
•
Change
•
Tighten container
Spray jet pulsates
•
Coating material in container
running out
•
Nozzle seal is missing or worn
•
Air lter heavily soiled
•
Rell
•
Insert an intact nozzle
seal
•
Change
Coating material
causes "paint tears"
•
Too much coating material
applied.
•
Turn material volume
adjusting screw to the
left
Too much fog of
coating material
(Overspray)
•
Distance to the object too large
•
Too much coating material
applied
•
Reduce distance
•
Turn material volume
adjusting screw to the
left
Paint in the
ventilating hose
•
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm
•
Replace the diaphragm
27. Maintenance
Check the air lter (g. 30, 1) after use and replace depending on how soiled it is.
Insert a new air lter (order no. 2310 812) and
replace the lid (2).
i
WARNING! Never operate the
machine without the air lter;
dirt could be sucked in and
interfere with the function of
the machine.
To make assembly easier, apply lubricant
(enclosed) to the specied areas after
cleaning (g. 31).