WAGO 752-823 - Base Module

System Description • 5
Fieldbus Dependent I/O Module
PROFIBUS DP
2.1 Base Module
The base module is the interface for all external wiring, including the fieldbus,
power supply, and sensor/actuator connections. A multi-conductor connector
links the external wiring to the plug-in electronic module.
12345678
9
10 11 12 13 14 15 16
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
17 18 25 26
WAGO-I/O-SYSTEM 752 PROFIBUS 16 DI/16DO
ITEM - NO. 752-823
Fertigungsnr.:
INPUT I
OUTPUT O
12345678
9
10 11 12 13 14 15 16
33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 480V
24V
Fig. 2-2: Base Module g1x2306x
• Fieldbus connection, 9 pole D-SUB
• Module power supply,
terminal block with CAGE CLAMP
®
2.5 mm² connection
• Sensor connection,
3 conductors, terminal block with CAGE CLAMP
®
1.5 mm² connection
• Actuator connection,
2 conductors, terminal block with CAGE CLAMP
®
1.5 mm² connection
• Separate output supply voltage,
terminal block with CAGE CLAMP
®
1.5 mm² connection
• Fuse holder with protective cap for input supply voltage fuse.
• Clear labeling of the connection group (INPUT or OUTPUT) and each in-
dividual terminal block (numbered)
• Wiring can be performed independent of the plug-in electronic module.