Attack
Waldorf 5 Operation Manual
System Requirements for Windows
In order to be able to use the Waldorf Attack, you will need at least:
A PC with a Pentium III / AMD Athlon 600 processor or better
64 MB free RAM
Windows 2000 / XP
VST 2.0 compatible host application supporting virtual instruments, such as Cubase
VST 3.7 or higher, Cubase SX/ SL/ SE or Nuendo 1.5 or higher. This must be cor-
rectly installed on your computer.
Please also observe the system requirements of your host application!
Installation under Windows
Proceed as follows to install the Attack:
1. Start your computer and launch your operating system.
2. Insert the Attack CD-ROM into your CD-ROM drive.
If you have enabled the Autostart function in Windows, the Installer will start automati-
cally and you can proceed with Step 6 below. If not, please proceed as follows:
3. Launch the Explorer or open the “My Computer” window.
4. Double click on the icon for the CD-ROM drive that holds the Attack-CD-ROM.
5. Double click on the Attack Installer icon. This launches a special installation pro-
gram.
6. Follow the on-screen instructions
The Attack CD-ROM is your verification that you have purchased the program. Please
store it in a safe place. If you lose it, you have lost the Program.
Please note the “Read Me” and “Important Changes” text files on the Attack CD-
ROM, which contain additional information and/or any changes.
System Requirements for Mac OS
In order to be able to use the Waldorf Attack, you will need at least:
Macintosh with 400 MHz G4 PowerPC processor or better
Mac OS X 10.3.9 or newer
128 MB free RAM
or
Macintosh with 1.5 GHz Intel CoreSolo processor or better
Mac OS X 10.4 or newer
128 MB of free RAM.
A VST 2.0 compatible host application that supports virtual instruments, such as Cu-
base SX / SL / SE or Nuendo. This must be correctly installed on your computer.
To Next Page
Loading...
