Walfront Mach3 - Table of Contents

Contents
Mach3 USB Motion Card (JDSW43A) Installation Manual...........................................................1
Contents................................................................................................................................................... 3
Features:
...................................................................................................................................................
4
Basic connection diagram (an Overview):
.........................................................................................
5
Mechanical dimensions diagram:........................................................................................................ 6
1.Prepare:
.................................................................................................................................................
6
1.1.Installation the Mach3:
...............................................................................................................
6
1.2.Software license application:.....................................................................................................7
1.3. Installation the software of the USB motion card:................................................................7
1.3.1 Connecting the USB cable to the PC and the motion card:
..........................................
7
1.3.2 Installing the motion card plug-in.....................................................................................8
2.config for mach3:................................................................................................................................9
2.1 Mach3 X
、
Y
、
Z
、
A Axis config as shown below: Config => Ports and Pins):
.........
9
2.2 Motor tuning setup as shown below: (Config => Motor Tuning)
.....................................
10
2.3 The Mach3 Menu => Config => Homing/Limits dialog：................................................10
2.4
Setup the input signal
：..........................................................................................................
10
2.5 Setup the Output signals:
.........................................................................................................
11
2.6 Spindle speed control (0-10V) Setup:
....................................................................................
12
2.6 Mach3 MPG Setup:...................................................................................................................14