18
www.WalkinPets.com
Putting Your Pet into the Fully Supportive
(Quad) Wheelchair
Aer the fully supportive wheelchair is assembled, place your pet's
legs into each leg ring. You can cross extra strapping from leg rings
over the body or Velcro together to form handles (p.11).
Height: Set the height so that all four toe pads on each of your pet’s
front paws are touching the ground. Extenders need to be parallel to
the ground.
Length: Pet’s front leg should be centered between the two shoulder
socket screws.
Width: Width is determined by the widest part of the dog (generally
the dog’s chest). Allow at least an inch of space on both sides.
Leg Rings: The leg rings in the front generally need to be a bit lower
than in the rear to accommodate your pet’s deeper chest. Adjust the
leg rings accordingly.
Side view (3" wheels) Front view (2" wheels)
To Next Page
Loading...