Walkin’ Pets Wheels - Setting Up the Dog Wheelchair; Adjusting the Length; Is the Length Correct?

7
(888) 253-0777
The Snap Buttons are an easy way to adjust the length, width, and height
of the Walkin’ Wheels® wheelchair. Use an Allen key to push the Snap
Button when it is inside the knuckle to make height adjustments.
Setting Up the Dog Wheelchair:
Use Snap Buttons to Adjust Length, Width,
and Height
Adjusting the Length
The extenders are for length adjustments. The kit comes with one set.
To adjust the extenders, depress the snap button and move to desired
length. The le and right are reversible.
Note: If you have the Front Wheel Attachment, remove the extenders
and skip to p.16.
Is the Length Correct?
The end of the extenders should be positioned at the center of your pet’s
shoulder blades. The extenders should be touching the neoprene pads
on the front harness and not pulling outward.
• Knuckles
should be in line
with the hips.
• Side bar should run parallel to the ground
through the center of the body.
• Side bars should end at the shoulder blade.