3
(888) 253-0777
Quick Start Guide
1. Set up wheelchair length (p.7), height (p.8), and width (p.8)
2. Attach Leg Rings to wheelchair (p.10)
3. Put Front Harness on your pet (p.11)
4. Put your pet in wheelchair:
Now that your pet is wearing the front harness, he/she is ready to
get started. The wheelchair should be positioned with extenders
slanted down on the ground. Get behind the wheelchair, li
your pet’s back legs up, and place legs into the leg rings (if your
pet is lightweight, you may li him/her to do so). When the legs
are through the rings, pull up extenders (side bars). Slide each
extender through the D-Ring on the front harness, and clip in place.
Instructional videos: hpets.net/swi
5. How to fit dog (adjustments p.13)
Perri
Tips for adjusting the wheelchair to your pet:
• Height: All four toe pads of both rear paws are touching the ground
• Length: Side extenders do not go past center of the front leg and the
rear hips are centered with the black knuckle
• Width: ½” - 1” between the body and the wheelchair frame at the
widest part of your pet (usually the chest)
To Next Page
Loading...
