6.10.4 Set the Splitting-Wedge Height
Adjust the height of the splitting wedge for one of the following
split types:
• Even-sized, four-way splits up to 22" (56 cm): align the
center of the splitting wedge with the center of the log.
• Smaller logs: lower the splitting wedge to the lowest setting
for a two-way split.
For more information, see Splitting-Wedge Height Adjustment
Lever on page 23.
Procedure:
1. Slightly pull the lever out of the adjustment cog.
2. Move the handle along the adjustment bar to the raise or
lower the splitting-wedge height.
3. Release the lever into an adjustment cog to set the splitting-
wedge height.
01228
Fig. 24 – Set the splitting-wedge height
6.10.5 Set the Log-length Guide
Set the log-length guide to the desired log length for consistent
saw cuts. The log-length guide can be set to cut logs from
14–24 inches (37–61 cm). Each setting is 2 inches (5 cm)
apart. The log cut lengths are shown on top of the guide rail.
1. Remove the snap-lock pin.
2. Move the guide to the desired position along the slide.
3. Insert the snap-lock pin to secure the guide.
01142
Fig. 25 – Set the log-length guide
WP845 / WP875
Trailer Firewood Processor
Operating Instructions
37
To Next Page
Loading...
