WAMGROUP MBF 042 - Page 152

5.0 INSTALLATION AND FIXING
VL
2
VAL.130.--.M.EN Issue: A1
09.16
27
SUPPLY:
C) 1 bush
H) 1 solenoid valve support bracket
B)%ROWVQXWVVSULQJZDVKHUVDQGÀDWZDVKHUV
&DUGERDUGER[
NOTE: During assembly the blade must rest on all bearings. Only after having checked this up - end valve for
actuator assembly.
1) Insert the pneumatic cylinder (A) in central bore on the upper crosspiece of the valve body.
2) )L[WKHF\OLQGHUE\LQVHUWLQJWKHEROWV0[WKHVSULQJZDVKHUVWKHÀDWZDVKHUVDQGWKHQXWVB) from
below and tighten crossways.
3) Fit the bush on the rod so that the sticker on the bush remains visible. Fix the bush by screwing on the nut
(D) and the self-locking nut (E).Tighten bolts and nuts.
4) Slide down the rod to match the bores on bush (C) and on blade (F).
1
2
34