Service
Manual
OLS-81-
10
Important Notes
Safety notes
Special safety notes for the OLS-81-10 level generators
You should also read the notes in the Operating Manual.
Caution!
LED sources are invisible to the human eye but may nevertheless cause permanent eye
injuries.
Before operating the instrument familiarize yourself with the following safety notes and
measures:
Safety notes and measures
Do not look at the source output or at cable ends when the source is on.
Do not turn on the source until all the optical fiber cables have been connected up properly.
Under no circumstances should the source output
be
inspected when the source is on
-
not
even with a microscope.
Only properly qualified technicians with the appropriate authorization may carry out repairs.
They must be familiar with the relevant safety regulations and the associated risks.
Areas must be designated as such and properly
secured as stipulated by the relevant safety
regulations (see Section "Warning Signs").
When optical equipments are being operated, safety regulations to IEC 11825-1,
EN
11 60825 part 1 (Europe) and 21 CFR1 O4O..lO (Japan) must always be observed.
Anti-static Measures
See Chapter 2.2 in the OLP-10 Service Manual.
Repair Guidelines for SMD boards
See Chapter 2.3 in the OLP-10 Service Manual.
Cleaning Instructions
See Chapter 2.4 in the OLP-10 Service Manual.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
