1
Safety instructions
AUTIONC
The hand-held transmitter is for indoor use
only. It is not water-proof. Do not leave the
transmitter outdoors.
AUTIONC
Never activate buttons on your transmitter
arbitrarily without visual contact to the sun
shading product. Children may not play with
this product - remote controls or transmitters
may not get into the hands of children!
Carry out the following steps in the sequence given to
ensure problem-free operation:
Please read these instructions carefully
Insert the batteries
Learn the hand-held transmitter into the receivers
Check that the system is functioning correctly
Commissioning
Films on commissioning can be found at:
http://www.warema.de/inbetriebnahme-
funksysteme
We recommend commissioning using the
WMS studio PC software.
Insert the supplied batteries into the battery compart-
ment as described in the "Maintenance" section. The
device is now ready to operate.
Learn the hand-held transmitter into the receivers. See
the "Commissioning functions" section
(When the receiver is delivered, it does not "know" any
transmitter initially and first needs to learn to which
transmitters it should respond. We refer to this process
as "learning".)
Always follow the operating and installation instructions
of the receivers.
OTEN In addition, you can obtain the "WMS applica-
tion brochure" with numerous practical exam-
ples of learning, making settings and WMS
networks; the brochure is available free of
charge from your specialist dealer. Alternatively,
the brochure can be downloaded at: http://
www.warema.de → Products → Controls →
WAREMA Mobile System. The WAREMA Mobile
System also enables a wide range of special
functions.
General information
Fig. 1 WMS Hand-held transmitter
The WAREMA Mobile System (WMS) Hand-held transmit-
ter is used for the remote control of WAREMA WMS receiv-
ers. The receivers send a confirmation of the received
commands, and the hand-held transmitter indicates that it
received the confirmation.
The WMS Hand-held transmitter supports 5 different prod-
uct types. Ten channels are available per product type and
up to 10 receivers can be learned in each channel.
To operate different products simultaneously and to recall
self-defined states, up to 10 different scenes can be de-
fined. A scene can be used to operate up to 200 receivers
with a single command.
The comfort control functions can be switched on and off
via the WMS Hand-held transmitter. The parameters of the
control functions that are stored in the receiver can be
displayed and changed.
When the WMS Hand-held transmitter operates a product,
it indicates whether the previous operation of the product
was by a control function. If a control function prevents
operation of the product (e.g. a wind alarm), this is also
displayed on the WMS Hand-held transmitter.
Intended use
This device was developed to control WAREMA Mobile
System (WMS) receivers. The approval of the manufacturer
must be obtained for uses outside of the purposes listed
in these instructions.
To Next Page
Need help?
General
