Waring WFP11S - Disassembly of Batch Bowl Parts; Removing the S-Blade; Removing Accessory Discs

9
DISASSEMBLY of BATCH BOWL PARTS
WFP11S & WFP14S
ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING.
r5VSOUIFCPXMDPWFSDMPDLXJTFVOUJMUIFTBGFUZJOUFSMPDLUBCPOUIFDPWFSJTEJTFOHBHFEBOEUIF
locking tabs are clear of the tabs on the bowl. The bowl handle will be at a position between
7 o’clock and 9 o’clock. In this position you can lift the cover off the bowl.
r3FNPWFUIFMBSHFGPPEQVTIFSGSPNUIFGFFEUVCF3FNPWFUIFTNBMMQVTIFSGSPNUIFMBSHFQVTIFS
Disassembly when removing the S-blade
r3FNPWFUIFXPSLCPXMGSPNUIFVOJUCZSPUBUJOHDMPDLXJTFMFGUUPEJTFOHBHFUIFUBCTPOUIFCPUUPN
of the bowl platform from the work bowl. When the bowl handle is on the left (about 7 o’clock
position), you can gently lift the bowl straight up and out.
It is recommended that you remove the bowl from the motor base before you remove
the S-blade.
r5PSFNPWFUIFCMBEFLFFQBTMJHIUEPXOXBSEQSFTTVSFPOUIFUPQPGUIFDFOUFSIVCPGUIFCMBEF
while removing the bowl from the motor base. This will form a seal to prevent food particles from
spilling into the center tube of the bowl and onto the motor base or the work surface. REMOVE
ALL FOOD AND LIQUID BEFORE REMOVING S-BLADE, OR BOWL WILL LEAK.
Then remove the S-blade from the bowl by pulling upward to unlock the seal. Handle the S-blade
with caution; the blades are extremely sharp.
Disassembly when removing an accessory disc
r%POPUSFNPWFUIFXPSLCPXMVOUJMUIFBDDFTTPSZEJTDJTSFNPWFE
r5PSFNPWFBOBDDFTTPSZEJTDQMBDFZPVSGJOHFSTPOUIFPVUFSFEHFPGUXPPQQPTJUFTJEFTPGUIFEJTD
and lift. The disc should remove cleanly. To remove the detachable stem, hold the disc in one hand
with the stem facing away from your hand. Be careful not to scrape your hand on any sharp edges;
depress the release switch with your thumb and rotate counterclockwise.
r3FNPWFUIFXPSLCPXMGSPNUIFVOJUCZSPUBUJOHDMPDLXJTFMFGUUPEJTFOHBHFUIFUBCTPOUIF
bottom of the bowl platform from the work bowl. When the bowl handle is on the left (about
7 o’clock position), you can gently lift the bowl straight up and out.
w ww . . co m
information@itm.com1.800.561.8187