13
Always operate rear handle at full throttle. If debris becomes wrapped around the attachment,
release the switch trigger, and remove the debris.
REPLACE TRIMMER LINE (See Figure 10.)
1.
Firmly press in the tabs on each side of the spool cover.
2.
Remove the spool cover from the spool housing.
3.
Remove any excess trimmer line or obstructions from the spool.
4.
Use a clean cloth to wipe away any debris from the spool, spool cover, or spool housing.
5.
Replace new trimmer line onto the spool housing.
6.
Align the tabs of the spool cover with the posts on the spool housing. Push the spool
cover until the tabs securely snap into the posts.
To Next Page
Loading...
