15
SPECIFICATIONS
Charger: C8360/8362
Input: 120-240VAC, 50/60Hz, Max.3A
Output: 63VDC. Max.4.5A
Weight: 2.6 lbs (1.2kg)
CHARGING PROCEDURE (See Figure 13.)
NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first
use to ensure that maximum run time can be achieved. This lithium-ion battery will not
develop a memory and may be charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take more time to fully charge the battery. This will enhance the life of the
battery. Once it is fully charged, the next charge will return to standard charging.
A fully discharged battery pack will require the allotted time as stated in the battery
manual. Plug the charger into an AC power outlet.
•Insert the battery into the charger.
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to
communicate the current battery status. They are as follows
To Next Page
Loading...
Need help?
General