WARRIOR WEP8001ST User Manual

OPERTATION
14
REMOVING / REPLACING STRING HEAD (See Figure 11.)
1. Line up the spacer hole up with the hole in the motor housing.
2. Place a small screw driver or metal rod (included) in the spacer hole.
3. Rotate the head clockwise to loosen and remove.
4. Reverse steps 1-3 to re-install the same string head.
Note: If you put a different model string head on this unit please follow the
manufacturer ’ s instructions to install that head.
CUTTING TIPS (See Figure 12.)
• Keep the trimmer tilted toward the area being cut; this is the best cutting area.
• The trimmer cuts when passing the unit from right to left. This will avoid throwing debris at the
operator. Avoid cutting in the dangerous area shown in figure 12.
• Use the tip of string to do the cutting; do not force string head into uncut grass.
• Wire and picket fences cause extra string wear and breakage. Stone and brick walls, curbs,
and wood may wear string rapidly.
• Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be
damaged by the string.
Fig.11
Cutting Area
Fig.12

WARRIOR WEP8001ST Specifications

General

Brand	WARRIOR
Model	WEP8001ST
Category	Trimmer
Language	English