WARNING
If any parts are damaged or missing, do not operate this product until the parts are replaced. Use of
this product with damaged or missing part could result in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories not recommended for use with this
blower. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
Do not connect to power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
ATTACHING THE GUARD
(See
Figure
3.)
NOTE: Install the guard before the attachment is connected to the rear handle.
•
R
emove the battery.
• Invert the string trimmer to access the trimmer head.
• Using a Phillips head screwdriver, remove the pre-installed screws from the trimmer head.
• Place the guard on to the trimmer head and slide the guard onto the head by following the
track on the head
• Align the screw holes on the guard with the screw holes on the trimmer head.
• Insert the screws into the trimmer head, fas
tening the guard in place.
To Next Page
Loading...
Need help?
General