21
29
3962
To change the wash programs
You can change the following parameters in the
wash programs by adding jumper wires to the
terminal block at the rear of the machine.
- no prewash
- only two rinses
Water level during prewash/mainwash
With jumper A (see figure) in place the machine
fills water to the high level during prewash,
mainwash and rinses.
If you remove jumper A the machine fills water to
the low level during pre- and mainwash and to
the high level during rinses.
Contact your local dealer for detailed information.
To change the wash programs
Fig.
29
Fig.
29
Terminal connection
To Next Page
Loading...
