28
Mechanical and electrical design
Water level controls
One pressure switch is used to control the correct water levels during
various cycles of the washing program.
Adjustment
All pressure switches are factory-calibrated to meet specific requirements.
The trip level for any one pressure switch can be changed only within
narrow limits because each trip range requires a different set of springs.
Call Wascomat's Service Department at 516-371-0700 before attempting to
adjust the level control.
Water level
As a guide for checking the level control for proper functioning, the normal
level should be approximately at the bottom of the door glass. It is primarily
the reverse-wash mechanical action of the washer which gets clothes
clean, not the level of water or amount of detergent. The water levels are
set at the factory to get a full load clean without wasting a drop of water, to
save you money and protect the environment.
1158
37
Fig.
37
To Next Page
Loading...
