9
Prepare the Cleaner for Use
a. Charging your cleaner
• End #1: To unit’s charging jack.
• End #2: To an Indoor Grounded
Residential power source.
Make sure there is no water present on
the pins of the Unit’s charging jack.
CHARGING TIME: 6-8 HOURS
Be sure to charge in a dry, shaded area.
1.
2.
(The CX-1 will not run when the charger is plugged in).
The robot cannot be charged while in the pool. But the robot can be charged immediately after removing from the pool. Just
make sure that the pins of the robot’s charging jack are dry before plugging in the charger.
Charger
Unit’s Charging Jack
DO NOT charge outside of the accepted temperature range: 41 to 113°F (5 to 45°C)
DO NOT use extension cord or power strip.
DO NOT expose charger to water or direct sunlight.
DO NOT leave unit plugged into charger for extended periods of time.
DO NOT leave unit plugged into charger during long term storage.
ONLY USE the charger that came with the unit.
To Next Page
Loading...
