20
Only follow the instructions below if instructed to by Water Tech or the
Troubleshooting / FAQs section.
Make sure that the batteries are FULLY CHARGED and the unit is
OUT OF WATER before calibrating.
Calibration Procedure: Read all instructions before attempting to calibrate robot.
CX-1 Calibration Procedure
1. Turn ON the robot.
3. The “Floor Only” LED light will ash
rapidly to indicate proper entry.
2. Within 5 seconds of turning the robot ON,
press the “Cleaning Mode” button 5 times.
x 5
4. Wait for the “Floor Only” LED to stop
ashing, then press the “Cleaning Mode”
button one time.
x 1
To Next Page
Loading...
