Water Tech Pool Blaster CX-1 - 12 Faqs

?
23
CX-1 FAQs
• See page 20 for calibration instructions.
4. If the problem persists, contact Water Tech Customer Service regarding a “Replacement Motor”.
• Robot is driving away during charging.
• Contact Water Tech Customer Service regarding a “Control Box” issue.
• Robot is not moving and “1-Day”, “Weekly”, “ON/OFF”, and Battery LEDs are all ON:
1. Turn the robot OFF and ON again using the Power (ON/OFF) Button.
2. Refer to page 10 for more information.
3. If problem persists, contact Water Tech Customer Service regarding a “Control Box” issue.
• Robot appears to be driving in circles or driving back and forth over the same area.
1. Robot may need calibration.
• See page 20 for calibration instructions.
2. If the problem persists, contact Water Tech Customer Service regarding a “Control Box” or “ Pump
Motor” issue.
• Robot is stuck upside-down in pool.
1. Flip the robot over – it should start back up immediately.
2. Batteries may be fully discharged and the robot will not turn back ON.
3. If the problem persists, clean out the lter bag and rinse the inside of the robot.
4. Otherwise contact Water Tech Customer Service regarding a “Control Box” issue.
• Robot is not covering the entire pool.
1. Try using di󰀨erent launch points: the robot has a tendency to spend more time in the deep end of
most pools. We recommend launching the robot in the shallow end.
• Filter Bag is not staying secure to bottom cover during use.
• Clean out the lter bag and bottom cover thoroughly.
• If the problem persists, contact Water Tech Customer Service regarding a “Replacement Bottom Cover”.
• Robot is driving around with the pump turned OFF.
• It is perfectly normal if this happens just after the robot falls o󰀨 a wall.
• If this issue occurs more frequently, the robot may need calibration, See page 20 for instructions
• If the problem persists, contact Water Tech Customer Service regarding a “Control Box” or “Pump
Motor” issue.
• Can I leave the robot in the pool?
• Yes, the robot can stay in the pool for up to 7 days, even with the battery fully depleted.
• Can I leave the robot on the charger?
• Yes, the robot can stay plugged into the charger for up to 7 days. However, the robot MUST be
charged in a DRY, SHADED AREA. Leaving the charger in water or direct sunlight WILL damage the
charger and VOID the warranty.
CX-1 Troubleshooting