Water Tech Pool Blaster Pulse - How to Remove the Battery


Never smoke or allow a spark or flame in the vicinity of the battery or the cleaner. Batteries ca
n
generate gases which could possibly ignite.

Do Not expose to fire or intense heat as this may result in an explosion.
C
AUTION!
I
f a battery leak develops, avoid contact with the leaking acid and place the damaged battery in
a
plastic bag.

If acid comes in contact with skin and clothing, wash immediately with plenty of soap and
water.

If acid comes in contact with eyes, immediately flood eye with running cool water for at least
15 minutes. Get medical attention immediately.
H
ow to remove the battery
R
ecommended tools (not included): Philips screwdriver, Slotted screwdriver and wrench socket/
a
djustable wrench.
1
. Use Philips screw driver to unfasten 4 screws under the filter base, and then detach the filter
b
ase, filter cone and filter sleeve from the main body.
2
. Unscrew the 2 small screws to release the cover.
3
. There is a slot on the extended screw base of main body. Insert Slotted screwdriver to the
s
lot of any one screw base and then pry the cover open. Remove the cover.