Water Tech Pool Blaster Pulse - Vacuum Head Assembly; Operation; General Operation Warnings

T
o release the telescopic pole, press down two side pins simultaneously and pull out the pole.
V
acuum head assembly
I
nsert the Vacuum Head adapter directly to the suction hole of the cleaner tightly by hand. Fig.
6
B
rushes on the vacuum head can be replaced if needed by removing the bottom cover.
I
t is recommended to keep both brushes and wheels on the vacuum head for most efficien
t
c
leaning and to prevent damage to your pool.
O
PERATION
W
ARNING!

Do not use the cleaner if any damage is found.

Do not operate this cleaner when people/pets are in the water.

Make sure the cleaner is fully immersed in the water immediately after powering on th
e
machine.

DO NOT operate it outside of water for more than 15 seconds, It will lead to failure of the shaf
t
seals / motor, and then VOID the warranty.

DO NOT use the cleaner without filter sock and sleeve in place. Using your cleaner withou
t
intact filter sock and sleeve in place will VOID your warranty.

Risk of Suction Entrapment Hazard. This cleaner generates suction. Avoid hair, body or an
y
loose parts of your clothing to contact with the suction hole of the cleaner in operation.
N
ever insert body parts, clothing or other objects into the openings and moving parts.